Removal Procedure
- Remove the radio and heater/AC control assembly. Refer to
Radio Replacement
.
- Remove the center console. Refer to
Console Replacement
in Instrument Panel, Gages and Console.
- Remove the right side insulator panel. Refer to
Instrument Panel Insulator Panel Replacement - Right Side
in Instrument Panel,
Gages and Console.
- Make note of body electrical
harness routing in the instrument panel.
- Disengage the body electrical harness (1) in the instrument
panel from the retainer (2).
- Remove the antenna cable from the instrument panel body electrical
harness.
- Remove the right side carpet retainer. Refer to
Carpet Retainer Replacement
in Interior Trim.
- Pull back the carpet in
order to gain access to the body electrical harness on the floor.
- Open the body electrical harness retainer on the right side of
the vehicle, in order to gain access.
- Remove the antenna cable (1) from the body electrical harness
on the right side of the vehicle.
- Remove the rear seat back. Refer to
Rear Seat Back Replacement
in Seats.
- Remove the body electrical
harness from the conduit (1).
- Remove the antenna cable from the body electrical harness.
- Guide the antenna cable (1)
into the rear compartment.
- Disconnect the antenna
cable (1) from the power antenna.
- Remove the antenna cable from the electrical harness in the rear
compartment.
- Remove the antenna cable from the vehicle.
Installation Procedure
- Install the antenna cable to the vehicle.
- Guide the cable (1)
from the rear compartment to the passenger compartment.
- Connect the antenna cable to the power antenna.
- Install the antenna cable
to the body wiring harness, using electrical tape, secure as necessary.
- Install the body electrical harness/antenna cable to the conduit (1).
- Install the antenna cable to the body electrical harness inside
the passenger compartment.
- Secure the coaxial cable with electrical tape as necessary.
- Install the rear seat back. Refer to
Rear Seat Back Replacement
in Seats.
- Install the body electrical
harness/antenna cable (1) to the wiring retainer on the right side
of the vehicle.
- Install the antenna cable to the wiring harness on the floor of
the vehicle.
- Secure the coaxial cable with new electrical tape as necessary.
- Install the right side of the carpet.
- Install the right side carpet retainer. Refer to
Carpet Retainer Replacement
in Interior Trim.
- Install the antenna cable to the instrument panel electrical
harness.
- Secure the coaxial cable with new electrical tape as necessary.
- Install the electrical
harness (1) to the instrument panel.
- Fasten the electrical harness retainer (2).
- Install the right side insulator panel. Refer to
Instrument Panel Insulator Panel Replacement - Right Side
.
- Install the center console. Refer to
Console Replacement
in Instrument Panel, Gages and Console.
- Install the radio and heater A/C control assembly. Refer to
Radio Replacement
.