GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 1998 🢒 Seville 🢒 Suspension 🢒 Front Suspension 🢒 Stabilizer Shaft Insulator Replacement

Removal Procedure

    Object Number: 104993 Size: SH
  1. Raise the vehicle and support by the frame allowing the control arms to hang free. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the wheels and tires.
  3. Loosen the stabilizer link bolts.

    4. Object Number: 104995 Size: SH
  4. Remove the stabilizer shaft brackets
  5. Remove the stabilizer shaft insulator from the bracket.

Installation Procedure

    Object Number: 104995 Size: SH
  1. Loosely install the right and left stabilizer shaft insulators, brackets and bolts.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.


    Object Number: 104993 Size: SH
  2. Loosely install the stabilizer link insulators, washers, nut and bolt.

    3. Tighten

        • Tighten the stabilizer bracket bolts to 38 N·m (28 lb ft).
        • Tighten the stabilizer link nut to 17 N·m (13 lb ft).
  3. Install the tires and wheels.

    4. Tighten
    Tighten the wheel nuts to 140 N·m (100 lb ft).

  4. Lower the vehicle.