Removal Procedure
- Remove the left sound
insulator panel. Refer to
Instrument Panel Insulator Panel Replacement
in Instrument Panel, Gauges
and Console.
- Twist the shift cable grommet and position away from the filter
access cover. It may be necessary to cut the tie strap, slice and peel back
the foam insulation to position the shift cable grommet out of the way to
access the filters.
- Remove the filter access
cover (1). Push down, then pull out.
- Remove the tape on the
first filter.
- Remove the first filter by pulling the filter tab.
- Remove the second filter by pulling the filter tab.
- Remove the third filter by pulling the filter tab.
Installation Procedure
- Install the first filter
into the HVAC module assembly.
- Use the tab and raise the filter, so that the leading edge catches
on the holding rib inside of the filter case.
- Install the second filter in the tab of the first filter.
- Slide the second filter into the remaining channels of the first
filter.
- Raise the filters, so that the leading edge catches on the holding
rib inside of the filter case.
- Install the third filter in the tab of the second filter.
- Slide the third filter into the remaining channels of the second
filter.
- Fold the second filter tab down and the third filter tab up over
the second.
- Install the filter access
cover (1).
- Reposition the shift cable
grommet. If the insulation was peeled back, it will be necessary to restrap
the foam back into the original position.
- Install the left sound insulator panel. Refer to
Instrument Panel Insulator Panel Replacement
in
Instrument Panel, Gauges and Console.