Was the entire Headlight System Check performed?

--

Go to Step 2

Go to Headlight System Check

1. Turn the headlamp switch to the ON position.
2. Backprobe with a DMM from battery positive voltage (B+) to the headlamp dimmer switch connector C202 cavity B11 (PNK/BLK).
3. Pull the headlamp dimmer toward the driver.

Is the voltage within the specified range?

10-15 V

Go to Step 3

Go to Step 5

1. Disconnect the headlamp dimmer switch connector C202.
2. Connect a DMM from the headlamp dimmer switch connector C202 cavity B7 (BLK) to ground.

Is the resistance less than the specified value?

0.5 ohms

Go to Step 4

Go to Step 8

Replace the headlamp dimmer switch. Refer to Turn Signal and Multifunction Switch Assembly - Off Vehicle in Steering Wheel and Column-Tilt.

Is the headlamp dimmer switch replacement complete?

--

Go to Headlight System Check

--

1. Remove the DMM.
2. Turn the ignition switch to the ON position.
3. Connect a scan tool to the data link connector (DLC).
4. Select INPUTS from the dash integration module (DIM) DATA DISPLAY.
5. Pull the headlamp dimmer toward the driver.

Did the scan tool indicate that the Flash To Pass Switch was ON?

--

Go to Step 6

Go to Step 7

Replace the dash integration module (DIM). Refer to Body Control Module Replacement in Body Control System.

Is the DIM replacement complete?

--

Go to Headlight System Check

--

Repair the open in CKT 1484 (PNK/WHT) between the DIM and the headlamp dimmer switch. Refer to Wiring Repairs in Wiring Systems.

Is the circuit repair complete?

--

Go to Headlight System Check

--

Repair the open in CKT 350 (BLK) between the headlamp dimmer switch and G200. Refer to Wiring Repairs in Wiring Systems.

Is the circuit repair complete?

--

Go to Headlight System Check

--