DEFINITION: The RF, LR or RR power window is inoperative at the selected door switch but functions properly when using the driver door window switches.

Was the Power Windows System Check performed?

--

Go to Step 2

Go to Diagnostic System Check - Power Door Systems

1. Connect a scan tool.
2. Select the data from the driver door module data list.
3. Operate the window switches at the malfunctioning door in the up and down directions.

Does the scan tool indicate that the switch operates correctly?

--

Go to Step 5

Go to Step 3

1. Disconnect the power window switch at the malfunctioning door.
2. Using a digital multimeter (DMM), measure the resistance between window switch terminal 2 and terminal 4 while pressing the switch in the down direction.
3. Using a DMM, measure the resistance between window switch terminal 1 and terminal 4 while pressing the switch in the up direction.

Is the resistance within the specified range for both measurements?

0-5 ohms

Go to Step 5

Go to Step 4

Replace the power window switch. Refer to Front Door Switch Replacement or Rear Side Door Window Switch Replacement .

Is the repair complete?

--

Go to Diagnostic System Check - Power Door Systems

--

1. Disconnect the door module connector C1 at the malfunctioning door.
2. Using a DMM, measure the resistance between window switch harness connector terminal 4 and door module harness connector terminal 10.

Is the resistance within the specified range?

0-5 ohms

Go to Step 7

Go to Step 6

Repair the open in one of the following circuits:

Refer to Wiring Repairs in Wiring Systems.

Is the repair complete?

--

Go to Diagnostic System Check - Power Door Systems

--

Using a DMM, measure the resistance between window switch harness connector terminal 2 and door module harness connector terminal 9.

Is the resistance within the specified range?

0-5 ohms

Go to Step 9

Go to Step 8

Repair the open in one of the following circuits:

Refer to Wiring Repairs in Wiring Systems.

Is the repair complete?

--

Go to Diagnostic System Check - Power Door Systems

--

Using a DMM, measure the resistance between window switch harness connector terminal 1 and door module harness connector terminal 8.

Is the resistance within the specified range?

0-5 ohms

Go to Step 11

Go to Step 10

Repair the open in one of the following circuits:

Refer to Wiring Repairs in Wiring Systems.

Is the repair complete?

--

Go to Diagnostic System Check - Power Door Systems

--

Replace the door module at the malfunctioning door. Refer to Door Control Module Replacement .

Is the repair complete?

--

Go to Diagnostic System Check - Power Door Systems

--