Removal Procedure
- Remove the door trim panel. Refer to Door Trim Panel Replacement .
- Remove the water deflector. Refer to Rear Side Door Water Deflector Replacement .
- Remove the rear stationary window. Refer to Rear Side Door Stationary Window and Front Channel Replacement .
- Locate the window clamps (2) on the regulator and loosen the bolts.
- Remove the window (1) by pulling it up and out of the door assembly.
Caution: When working with any type of glass or sheet metal with exposed or rough edges, wear approved safety glasses and gloves in order to reduce the chance of personal injury.
Installation Procedure
- Install the window (1) down into the door assembly.
- Install the rear stationary window. Refer to Rear Side Door Stationary Window and Front Channel Replacement .
- Locate the window into the two clamps.
- Connect a power source to the window motor and run the window to the full up position.
- Install water deflector. Refer to Rear Side Door Water Deflector Replacement .
- Install door trim panel. Refer to Door Trim Panel Replacement .
- Check the window and door controls for proper operation.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the window clamp bolts to 11 N·m (97 lb in).
