Removal Procedure
- Remove the door trim panel. Refer to Door Trim Panel Replacement
- Remove the water deflector. Refer to Front Side Door Water Deflector Replacement
- Loosen regulator window clamp bolts.
- Manually move glass to up position and hold in place with tape.
- Remove the five retainer bolts (1) and (2).
- Disconnect the electrical connector from the window regulator motor.
- Remove the window regulator (1) from the door.
Caution: Disconnect the power window switch when working inside the driver door. When operated, the Express Up/Down Feature allows the door window to move very quickly, without stopping, which could cause personal injury.
Installation Procedure
- Install the window regulator (1) into the door.
- Locate the two captive bolts (2) into the keyhole slots in the door panel.
- Install the three remaining bolts (2) to secure the regulator.
- Install the window to clamps.
- Connect electrical connector to window regulator motor.
- Install the water deflector. Refer to Front Side Door Water Deflector Replacement
- Install the door trim panel. Refer to Door Trim Panel Replacement
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the window regulator bolts to 9 N·m (80 lb in).
Tighten
Tighten window clamp bolts to 11 N·m (97 lb in).
