Removal Procedure
- Lower the window half way down to gain access to the window retainer clamp bolts (1).
- Remove the door trim panel. Refer to Door Trim Panel Replacement .
- Remove the water deflector. Refer to Rear Side Door Water Deflector Replacement .
- Loosen the window retainer clamp bolts.
- Slide the window to the full up position.
- Loosen the two captured bolts (2).
- Remove the three remaining bolts (3).
- Disconnect the electrical connector from the motor.
- Slide the window regulator upward to release the two captured bolts from the keyhole slots.
- Remove the window regulator.
Important: It may be necessary to use masking tape to hold the window into place while removing the regulator.
Installation Procedure
- Install the window regulator into the door.
- Locate the two captured bolts (2) into the keyhole slots.
- Slide the regulator downward to engage the two captured bolts.
- Install the three remaining bolts (3).
- Connect the window motor electrical connector.
- Slide the window down into the window retainer clamps.
- Install the water deflector. Refer to Rear Side Door Water Deflector Replacement .
- Install the door trim panel. Refer to Door Trim Panel Replacement .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the window regulator bolts to 9 N·m (80 lb in).
Tighten
Tighten the window retainer clamp bolts to 11 N·m (97 lb in).
