For 1990-2009 cars only
Info - Revised Console Trim Plate Removal Procedure
| Subject: | Revised Console Trim Plate Removal Procedure |
| Models: | 1998--2001 Cadillac Seville |
This bulletin is being revised to add the 2000 and 2001 model years and additional graphic information. Please discard Corporate Bulletin Number 83-83-21 (Section 8 -- Body & Accessories).
If the console trim plate is not properly removed, damage may occur in the following areas:
| • | Stress cracks (1) at the left and right hand front corners next to the storage/ashtray compartment and at the left and right hand rear corners next to the chrome trim. |
| • | Chips in the lacquered surface along the edge of the trim plate. |
These conditions may be caused by the following:
| • | Excessive force used when lifting the console trim plate up and out. |
| • | Using a sharp tool when prying between the trim plate and the top portion of the vinyl trim of the console assembly. |
Removal Procedure
Important: DO NOT USE THE CONVENIENCE DOOR OPENING AS A LEVERAGE POINT.
- Block the wheels on the vehicle.
- Put the shifter lever into neutral (N).
- Remove the console trim plate.
- Lift the console trim plate assembly upwards from the rear edge and pull the assembly rearward.
- Disconnect the electrical connectors as necessary.
Notice: To prevent possible component damage, DO NOT use tools to remove the console trim plate.
| 3.1. | Insert your fingers (if necessary, use a flat plastic tool) between the trim plate and the PRNDL at the RH rear corner of the chrome trim (2). |
| 3.2. | Gently lift up the trim plate in order to disengage the RH rear corner retainer (3). |
| 3.3. | Use the same method at the LH rear corner and the two front corners of the chrome trim in order to disengage the remaining retainers. |
Warranty Information
For vehicles repaired under warranty, use:
Labor Operation | Description | Labor Time |
|---|---|---|
C2790 | Plate Console Trim - Replace | Use published labor operation time |
