GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2000 🢒 Seville 🢒 Engine 🢒 Engine Controls - 4.6L 🢒 Accelerator Control Cable Bracket Replacement

Removal Procedure

    Object Number: 104766 Size: SH
  1. Disconnect the cruise control cable (2) from the accelerator controls cable bracket (1).
  2. Disconnect the accelerator cable (3) from the accelerator controls cable bracket (1).

    3. Object Number: 574905 Size: SH
  3. Disconnect the fuel feed (4) and fuel return (2) fuel pipes from the retainer (5).

    4. Object Number: 154854 Size: SH
  4. Disconnect the transaxle vent hose clip (2) from the accelerator controls cable bracket (1).

    5. Object Number: 573471 Size: SH
  5. Remove the bolts (2) from the accelerator controls cable bracket (3).
  6. Remove the accelerator controls cable bracket (3) from the throttle body (1).

Installation Procedure

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.


    Object Number: 573471 Size: SH
  1. Install the accelerator controls cable bracket (3) to the throttle body (1).

    2. Tighten
    Tighten the bolts to 12 N·m (106 lb in).


    Object Number: 574905 Size: SH
  2. Connect the fuel feed (4) and fuel return (2) fuel pipes to the retainer (5).

    3. Object Number: 154854 Size: SH
  3. Connect the transaxle vent hose clip (2) to the accelerator controls cable bracket (1).

    4. Object Number: 104766 Size: SH
  4. Connect the cruise control cable (2) from the accelerator controls cable bracket (1).
  5. Connect the accelerator controls cable (3) from the accelerator controls cable bracket (1).