Removal Procedure
- Remove the rear seat cushion. Refer to Rear Seat Cushion Replacement in Seats.
- Disconnect the battery negative cable from the battery. Refer to Battery Negative Cable Disconnection and Connection .
- Disconnect the positive battery cable (1) from the battery.
- Remove the battery vent tube (1) from the battery.
- Remove the battery retainer bolt and battery retainer.
- Remove the battery from the vehicle.
Installation Procedure
- Install the battery into the vehicle.
- Install the retainer and bolt.
- Install the battery vent tube (1) to the battery.
- Connect the positive battery cable (1) to the battery.
- Connect the battery negative cable to the battery. Refer to Battery Negative Cable Disconnection and Connection
- Install the rear seat cushion. Refer to Rear Seat Cushion Replacement in Seats.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the battery retainer bolt to 17 N·m (13 lb ft).
Important: Ensure the vent tube (1) is properly routed through the floor pan grommet.
Tighten
Tighten the battery cable bolt to 17 N·m (13 lb ft).
