Tools Required

J 35777 Caliper Piston Seal Installer

1. Remove the caliper from vehicle. Refer to Brake Caliper Replacement .

Caution: Do not place your fingers in front of the piston in order to catch or protect the piston while applying compressed air. This could result in serious injury.

2. Remove the piston by directing dry, filtered, low pressure compressed air into the caliper (5) inlet hole.




Important: Care must be used when removing the piston boot and seal from the caliper. Use a small plastic or wood tool for removal. Do not use a metal tool because it may damage the caliper bore or seal groove.

3. Remove the piston boot from the caliper.
4. Remove the piston seal from the caliper.
5. Remove the bleeder valve and cap from the caliper.



6. Clean all of the parts. Use clean, denatured alcohol. Dry all of the parts with dry, filtered, low pressure compressed air. Blow out all of the passages in the caliper body and the bleeder valve.
7. Inspect all of the parts as follows.

•	Piston - Inspect for scoring, nicks, cracks, wear, or corrosion. Replace the piston if any damage is found.

•	Caliper Bore - Inspect for scoring, nicks, cracks, wear, or corrosion. Use crocus cloth to polish out light corrosion. Otherwise, replace the caliper. Do not hone the caliper bore.

•	Seal groove in the caliper bore for nicks or burrs. If found, replace the caliper.

8. Install the new piston seal. Lubricate the seal with clean brake fluid before installing.



9. Install the new piston dust boot seal over the piston.
10. Using the J 35777 fully seat the boot in the caliper.
11. Install the bleeder valve cap and bleeder valve into the caliper.
12. Install the caliper onto the vehicle. Refer to Brake Caliper Replacement .
13. Bleed the brake system. Refer to Power Steering System Bleeding .