For 1990-2009 cars only
Removal Procedure
- Disconnect the negative battery cable from the battery. Refer to Battery Negative Cable Disconnection and Connection .
- Remove the cover (2) from the underhood fuse block.
- Disconnect the positive battery cables nut (1) from the underhood fuse block.
- Disconnect the four locking tabs from the underhood fuse block and lift the assembly up from the base.
- Loosen the three screws retaining the underhood fuse block connectors.
- Disconnect the engine harness connector from the underhood fuse block.
- Remove the underhood fuse block from the vehicle.
Installation Procedure
- Connect the engine harness electrical connector to the underhood fuse block.
- Position the underhood fuse block to the base.
- Install the three screws retaining the underhood fuse block connectors.
- Install the underhood fuse block by pressing into the four locking tabs.
- Connect the positive battery cables nut (1) to the underhood fuse block.
- Install the cover (2) to the underhood fuse block.
- Connect the negative battery cable to the battery. Refer to Battery Negative Cable Disconnection and Connection .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the three screws to 7 N·m (62 lb in).
Tighten
Tighten the nut to 12 N·m (106 lb in).
