Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the Lighting Systems Diagnostic System Check? | -- | Go to Step 2 | |
2 | Backprobe the hazard switch assembly connector with a DMM from cavity G (ORN) to cavity C (WHT). Is the voltage within the specified range? | 10-15 V | Go to Step 3 | Go to Step 6 |
3 |
Does the scan tool indicate that the Theft Lighting output was ON? | -- | Go to Step 4 | Go to Step 6 |
4 | Disconnect the DIM connector C1. Do the hazard lamps turn off? | -- | Go to Step 5 | Go to Step 7 |
5 | Replace the dash integration module (DIM). Refer to Dash Integration Module Replacement in Body Control System. Is the DIM replacement complete? | -- | Go to Step 8 | -- |
6 | Replace the hazard switch assembly. Refer to Hazard Warning Switch Replacement . Is the hazard switch assembly replacement complete? | -- | Go to Step 8 | -- |
7 | Repair the short to ground in CKT 111 (WHT). Refer to Wiring Repairs in Wiring Systems. Is the circuit repair complete? | -- | Go to Step 8 | -- |
8 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK. | Go to Step 2 |
