Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the Lighting Systems Diagnostic System Check? | -- | Go to Step 2 | |
2 |
Is the voltage within the specified range? | 10-15 V | Go to Step 3 | Go to Step 6 |
3 | Backprobe the hazard switch assembly connector with a DMM from cavity B (DK GRN) (LH) or cavity D (LT GRN) (RH) to ground. Is voltage within specified range? | 10-15 V | Go to Step 4 | Go to Step 7 |
4 | Backprobe the hazard switch assembly connector with a DMM from cavity K (LT BLU) (LH) or cavity H (DK BLU) (RH) to ground. Is the voltage within the specified range? | 10-15 V | Go to Step 5 | Go to Step 8 |
5 | Repair the open in CKT 14 (LT BLU) (LH) or CKT 15 (DK BLU) (RH) between the hazard switch assembly and C201. Refer to Wiring Repairs in Wiring Systems. Is the circuit repair complete? | -- | Go to Step 11 | -- |
6 | Replace the turn signal switch. Refer to Multifunction Turn Signal Lever Replacement - On Vehicle in Steering Wheel and Column-Tilt. Is the turn signal switch replacement complete? | -- | Go to Step 11 | -- |
7 | Repair the open in CKT 1428 (DK GRN) (LH) or CKT 1427 (LT GRN) (RH) between the turn signal switch and the hazard switch assembly. Refer to Wiring Repairs in Wiring Systems. Is the circuit repair complete? | -- | Go to Step 11 | -- |
8 |
Is the resistance less than the specified value? | 5 ohms | Go to Step 9 | Go to Step 10 |
9 | Repair the short to ground in CKT 14 (LT BLU) (LH) or CKT 15 (DK BLU) (RH). Refer to Wiring Repairs in Wiring Systems. Is the circuit repair complete? | -- | Go to Step 11 | -- |
10 | Replace the hazard switch assembly. Refer to Hazard Warning Switch Replacement . Is the hazard switch assembly replacement complete? | -- | Go to Step 11 | -- |
11 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK. | Go to Step 2 |
