Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you review the Wiper/Washer System Description and Operation and perform the necessary inspections? | -- | Go to Step 2 | Go to Symptoms |
2 |
Are the wipers still operating? | -- | Go to Step 6 | Go to Step 3 |
3 | Inspect for a short to voltage in the pigtail wires leading to the wiper/washer switch. Was a short to voltage found? | -- | Go to Step 4 | Go to Step 5 |
4 | Repair the short to voltage in the wiper/washer switch pigtail wires. Is the repair complete? | -- | Go to Step 19 | -- |
5 | Replace the wiper/washer switch. Refer to Multifunction Turn Signal Lever Replacement - On Vehicle . Is the replacement complete? | -- | Go to Step 19 | -- |
6 | Turn the ignition OFF and then back to RUN. Are the wipers still operating? | -- | Go to Step 8 | Go to Step 7 |
7 | Replace the wiper motor cover. Refer to Wiper Motor Cover Replacement . Is the replacement complete? | -- | Go to Step 19 | -- |
8 | Measure the voltage from connector 202 (vehicle side), terminal A5, to ground using a J 39200 . Is the measurement greater than the specified value? | 1.0 V | Go to Step 9 | Go to Step 12 |
9 |
Is the measurement greater than the specified value? | 1.0 V | Go to Step 11 | Go to Step 10 |
10 | Replace the wiper motor cover. Refer to Wiper Motor Cover Replacement . Is the replacement complete? | -- | Go to Step 19 | -- |
11 | Repair the short to voltage in CKT 478. Is the repair complete? | -- | Go to Step 19 | -- |
12 | Measure the voltage from the connector C202 (vehicle side), terminal D3, to ground using a J 39200 . Is the measurement greater than the specified value? | 1.0 V | Go to Step 16 | Go to Step 13 |
13 |
Is the measurement within the specified values? | 10.5-15 V | Go to Step 14 | Go to Step 15 |
14 | Repair the short to voltage in CKT 92. Is the repair complete? | -- | Go to Step 19 | -- |
15 | Replace the wiper motor cover. Refer to Wiper Motor Cover Replacement . Is the replacement complete? | -- | Go to Step 19 | -- |
16 |
Is the measurement greater than the specified value? | 1.0 V | Go to Step 17 | Go to Step 18 |
17 | Repair the short to voltage in CKT 477. Is the repair complete? | -- | Go to Step 19 | -- |
18 | Replace the wiper motor cover. Refer to Wiper Motor Cover Replacement . Is the replacement complete? | -- | Go to Step 19 | -- |
19 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Symptoms |
