Did you review the Wiper/Washer System Description and Operation and perform the necessary inspections?

--

Go to Step 2

Go to Symptoms

1. Turn the ignition switch to ON.
2. Set the wiper switch to LO.
3. Disconnect wiper motor harness connector.
4. Connect a J 35616-200 from wiper motor connector (harness side) terminal G to ground.
5. Momentarily activate the washer switch while observing the J 35616-200 .

Is the test light on when the washer switch is released?

--

Go to Step 3

Go to Step 4

Replace the wiper/washer switch. Refer to Multifunction Turn Signal Lever Replacement - On Vehicle .

Is the replacement complete?

--

Go to Step 5

--

Replace the wiper motor cover. Refer to Wiper Motor Cover Replacement .

Is the replacement complete?

--

Go to Step 5

--

Operate the system in order to verify the repair.

Did you correct the condition?

--

System OK

Go to Symptoms