Did you perform the brake warning diagnostic system check?

--

Go to Step 2

Go to Brake Warning System Check

1. Disconnect the brake fluid level switch.
2. Connect a DMM between the brake fluid level switch connector terminal A and terminal B in order to measure the voltage.
3. Turn on the ignition.

Is the voltage within the specified range?

5 V

Go to Step 6

Go to Step 3

1. Connect a DMM between the brake fluid level switch connector terminal A and ground.
2. Turn on the ignition.

Is the voltage within the specified range?

5 V

Go to Step 7

Go to Step 4

1. Instrument panel cluster connector C2 connected.
2. Connect a DMM between the instrument panel cluster connector C2 terminal B4 and ground.

Is the voltage within the specified range?

5 V

Go to Step 5

Go to Step 8

1. Repair an open in CKT 333 (PPL). Refer to Connector Repairs in Wiring Systems.
2. Test the CKT for an open to B+.

Did you complete the repair?

--

Go to Brake Warning System Check

--

Replace the brake fluid level switch. Refer to Master Cylinder Reservoir Replacement .

Did you complete the repair?

--

Go to Brake Warning System Check

--

Repair an open in CKT 51 (BLK/WHT). Refer to Connector Repairs in Wiring Systems. Test the CKT for an open to B+.

Did you complete the repair?

--

Go to Brake Warning System Check

--

Replace the instrument panel cluster. Refer to Instrument Cluster Replacement .

Did you complete the repair?

--

Go to Brake Warning System Check

--