Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
DEFINITION: The engine oil level is low, but the CHECK OIL LEVEL message does not display on the DIC. | ||||
1 | Did you perform the Instrument Cluster Diagnostic System Check? | -- | Go to Step 2 | |
2 |
Does the scan tool display OK? | -- | Go to Step 3 | Go to Step 9 |
3 |
Does the scan tool display LOW? | -- | Go to Step 6 | Go to Step 4 |
4 | Test the signal circuit of the engine oil level switch for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 10 | Go to Step 5 |
5 | Inspect for poor connections at the harness connector of the powertrain control module (PCM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 10 | Go to Step 7 |
6 | Inspect for poor connections at the harness connector of the engine oil level switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 10 | Go to Step 8 |
7 | Replace the PCM. Refer to Powertrain Control Module Replacement/Programming in Engine Controls - 4.6L. Did you complete the replacement? | -- | Go to Step 10 | -- |
8 | Replace the engine oil level switch. Refer to Engine Oil Level Sensor Replacement . Did you complete the replacement? | -- | Go to Step 10 | -- |
9 | Replace the instrument cluster (IPC). Refer to Instrument Cluster Replacement . Did you complete the replacement? | -- | Go to Step 10 | -- |
10 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Step 2 |
