Caution: When you are performing service on or near the SIR components or the SIR wiring, you must disable the SIR system. Refer to Disabling the SIR System. Failure to follow the correct procedure could cause air bag deployment, personal injury, or unnecessary SIR system repairs.

1. Remove the front bucket seat. Refer to Front Seat Replacement - Bucket .
2. Remove the front seat cushion . Refer to Front Seat Cushion Replacement .
3. If the cable is equipped with a position sensor, remove the sensor retention clip and disconnect the electrical connector.



4. Squeeze the collar of the cable in order to release the cable.



5. Pull the cable out of the fitting until the cable end clears the fitting.
6. Remove the cable or cable/sensor assembly.

1. Install the cable or cable/sensor assembly by pushing the ends into the fittings until the clip snaps into place.
2. If the cable is equipped with a position sensor, install the sensor retention clip and connect the electrical connector.
3. Install the front seat cushion. Refer to Front Seat Cushion Replacement .
4. Install the front bucket seat. Refer to Front Seat Replacement - Bucket .