Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the Rear Compartment Lid Release System Check | -- | ||
2 | Press the trunk lid release button on the keyless entry transmitter. Does the trunk lid open? | -- | ||
3 |
Is the input ON when the trunk release button is pressed and OFF when the button is released? | -- | ||
4 |
Is the resistance within the range specified? | 0-3 ohms | ||
5 | Using a fused jumper wire, jumper terminal 5 of the switch assembly harness connector to ground. Does the trunk lid open? | -- | ||
6 | Press the fuel door release switch on the instrument panel. Does the fuel door open? | -- | ||
7 |
Does the scan tool indicate that the input toggles OFF/ON? | -- | ||
8 | With the rear compartment release switch disconnected, check the resistance from pin 4 of the release switch connector to ground. Is the resistance within the specified range? | 0-3 ohms | ||
9 |
Does the scan tool indicate that the output toggles OFF/ON? | -- | ||
10 | With the connecter still connected, check the voltage at pin A10 connector C2 of the rear junction block. Is the value within the specified range? | 10.5-15 V | ||
11 | Check the ALDL fuse in the rear junction block. Is the fuse good? | -- | ||
12 | Inspect the ALDL fuse and the BODY fuse located in the rear junction block. Are both fuses good? | -- | ||
13 |
Does the trunk lid open? | -- | ||
14 | Measure the voltage at terminal A of the rear compartment lid release solenoid harness connector. Is the voltage within specified range? | 10.5-15 V | ||
15 | Measure the voltage at pin A9 connector C2 of the rear fuse block. Is the value within the specified range? | -- | ||
16 |
Is the voltage within specified range? | 10.5-15 V | ||
17 | Check CKT 850 for an open. Is there an open? | -- | ||
18 | Check CKT 1447 for an open. Is there an open? | -- | ||
19 | Repair open in CKT 1447. Is the repair complete? | -- | -- | |
20 | Replace the instrument panel integration module. Is the repair complete? | -- | -- | |
21 | Repair open in CKT 351. Is the repair complete? | -- | -- | |
22 | Check the rear compartment lid release switch connector for poor terminal contact. If OK, replace switch. Is the repair complete? | -- | -- | |
23 | Repair open in CKT 56 . Is the repair complete? | -- | -- | |
24 | Replace the fuse. Is the repair complete? | -- | -- | |
25 | Replace the rear interface module (RIM). Is the repair complete? | -- | -- | |
26 | Replace the TRK relay. Is the repair complete? | -- | -- | |
27 | Measure the voltage at pin C1 connector C2 of the rear fuse block. Is the value within the specified range? | 10.5-15 V | ||
28 | Measure the voltage at pin A of the valet switch. Is the value within the specified range? | 10.5-15 V | ||
29 | Measure the voltage at pin B of the valet switch. Is the value within the specified range? | 10.5-15 V | ||
30 | Check CKT 253 for an open. Is there an open? | -- | ||
31 | Repair open in CKT 3640. Is the repair complete? | -- | -- | |
32 | Replace the valet switch. Is the repair complete? | -- | -- | |
33 | Repair open in CKT 253. Is the repair complete? | -- | -- | |
34 | Replace the rear compartment lid release solenoid. Is the repair complete? | -- | -- | |
35 | Repair open in CKT 850. Is the repair complete? | -- | -- |
