Circuit Description
The circuit for the LH Rear Power Window consists of:
| • | LH Rear Power Window Switch |
| • | LH Rear Door Module (LRDM) |
| • | Simple Bus Interface (SBI) |
| • | Driver Door Module |
The LH Rear Power Window Switch provides input to the LRDM. The LRDM contains a software program to sample the window switch and to report all switch activity in the form of SBI messages to the driver door module. The actual diagnostic software program for DTC B2204 is contained in the driver door module and the diagnostic is run no less than once every 300 milliseconds. Problems involving the driver door module or the SBI may set other DTC and will affect the operation of the power door locks and outside rearview mirrors.
Conditions for Setting the DTC
If the driver door module detects that the SBI messages from the LRDM show that the LH Rear Window Switch has been in the UP position for 15 continuous seconds, this DTC will be set current. This diagnostic will not run if either DTC B1982 (Battery Voltage High) or B1983 (Battery Voltage Low) are current.
Action Taken When the DTC Sets
This DTC is dynamic, and as such, is current only while the problem is present. While this DTC is current, the LRDM will ignore any actuation of the LH Rear Power Window Switch.
Conditions for Clearing the DTC
| • | This DTC will set from current to history when the window UP input cycles off or the power mode changes from OFF to RUN. |
| • | The history DTC will clear after 50 ignition cycles. |
| • | Use the On-Board clearing DTC feature. |
| • | Use a scan tool. |
Diagnostic Aids
| • | A history DTC is evidence of a intermittent problem. |
| • | If DTC B2204 is current, cycle the ignition switch from OFF to RUN. If this DTC is still current, perform the following diagnostic. |
Test Description
The numbers below refer to the step numbers on the diagnostic table:
-
Perform the Power Door Diagnostic System Check prior to continuing the diagnosis of this DTC.
-
This step tests the LH rear power window switch for an internal short.
-
This step tests CKT 1185 for a short to ground.
-
This repair procedure requires the of repair CKT 1185 for a short to ground.
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
Did you perform Diagnostic System Check - Power Door Systems ? | -- | Go to Step 2 | ||
Does the scan tool indicate UP? | -- | Go to Step 4 | Go to Step 3 | |
3 | Replace the LH rear power window switch. Refer to Rear Side Door Window Switch Replacement . Is the repair complete? | -- | Go to Step 7 | -- |
Is the resistance within the specified range? | 0-5 ohms | Go to Step 5 | Go to Step 6 | |
Repair CKT 1185 for a short to ground. Refer to Wiring Repairs in Wiring Systems. Is the repair complete? | -- | Go to Step 7 | -- | |
6 | Replace the LRDM. Refer to Door Control Module Replacement . Is the repair complete? | -- | Go to Step 7 | -- |
7 |
Are all DTCs cleared? | -- | -- |
