Circuit Description
Eight steering wheel control switches are used to control four audio and four HVAC functions. When the vehicle is equipped with the cellular telephone option, four telephone switches take the place of the HVAC steering wheel controls. The steering wheel controls are configured as a resistive ladder network connected to the dash integration module (DIM). When the vehicle is in ON, ACCY or RAP, battery voltage is provided from the DIM to the steering wheel controls. Pressing a switch (or switches) causes a voltage to appear on the return circuit which has a value unique to the switch(es) pressed.
Conditions for Setting the DTC
| • | DTC B2510 only sets if B1982 or B1983 is not current in DIM memory. |
| • | DTC B2510 sets if the DIM determines that a steering wheel controls HVAC switch is stuck. |
Action Taken When the DTC Sets
| • | DTC B2510 is stored in the DIM memory. |
| • | The module disables the steering wheel control functions as long as this DTC is current. |
| • | This DTC does not cause a driver warning message to appear. |
Conditions for Clearing the DTC
| • | A current DTC clears (status changes from current to history) if the conditions which caused the DTC to set are no longer present. |
| • | A history DTC clears after 50 consecutive ignition cycles if the condition for the malfunction is no longer present. |
Test Description
The numbers below refer to the step numbers on the diagnostic table:
-
Perform the Radio/Audio System Diagnostic System Check before continuing with the diagnosis of this DTC.
-
Clear all DTCs and cycle ignition to check that the DTC did not erroneously set.
-
Clear all DTCs after the repair procedure is complete.
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
Was the Radio/Audio System Diagnostic System Check performed? | -- | |||
Is the DTC still present? | -- | |||
3 |
Does the scan tool display 0 counts? | -- | ||
4 | On the scan tool, monitor the steering wheel controls A/D input. Does the scan tool display between 15 and 60 counts? | -- | ||
5 | On the scan tool, monitor the steering wheel controls A/D input. Does the scan tool display 15 counts or less, or more than 60 counts? | -- | ||
6 | Replace LH side steering wheel controls. Is the replacement complete? | -- | -- | |
7 | Replace the Dash Integration Module (DIM). Is the replacement complete? | -- | -- | |
Are all DTCs cleared? | -- | -- |
