Schematic Reference: Instrument Cluster Schematics

Connector End View Reference: Instrument Panel, Gages, and Console Connector End Views

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle

1. Install a scan tool.
2. Start the engine.
3. With the scan tool, perform the instrument panel cluster (IPC) Gages Oil Pressure Gage Sweep Test.

Does the engine oil pressure gage move up and down when commanded?

Go to Testing for Intermittent Conditions and Poor Connections

Go to Step 3

Replace the IPC. Refer to Control Module References for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 4

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2