Important: A short to ground will cause a open fuse(s). Before performing this diagnostic procedure, inspect the fuse(s) for an open.

1. Ensure that the battery is fully charged.
2. Remove the F/P INJ Fuse.
3. Measure voltage across the battery terminals with a DMM while attempting to crank the engine.

Is voltage measured within the specified range?

9.6 V or Greater

Go to Step 2

Go to Battery Load Test .

Measure voltage drop with a DMM between the negative battery terminal and the engine block while attempting to crank the engine.

Is the voltage drop within the specified range?

0.5 V or Less

Go to Step 3

Go to Step 4

Measure voltage between the positive battery terminal and the starter solenoid terminal B while attempting to crank the engine.

Is voltage measured within the specified range?

0.5 V or Less

Go to Starter Motor Replacement

Go to Step 5

Clean the terminals or replace the negative battery cable between the battery and the engine block.

Is repair complete?

--

System OK

--

Clean the terminals or replace the positive battery cable between the battery and the starter motor.

Is repair complete?

--

System OK

--