Tools Required

KM-507-C Ball Joint Remover

1. Remove the outer tie rod hex nut and disconnect the outer tie rod from the steering knuckle using the special tool KM-507-C .




Important: Before loosening the tie rod lock nut, mark the position of the lock nut for easy alignment after installation procedure.

2. Loose the tie rod lock nuts and remove the outer tie rod.

Notice: Refer to Fastener Notice in the Preface section.




1. Install the outer tie rod by tightening the lock nuts.

Tighten
Tighten the nuts to 54 N·m (40 lb ft).




2. Install the outer tie rod by tightening the hex nut.

Tighten
Tighten the nut to 45 N·m (33 lb ft).

3. Inspect the vehicle. Refer to Preliminary Alignment Inspection and Straight Ahead Diagnosis .
4. Measure the wheel alignment.
5. If necessary, adjust the front toe. Refer to Front Toe Adjustment .