Step
| Action
| Value(s)
| Yes
| No
|
1
| Did you perform the DRL System
Check?
| --
|
Go to Step 2
| Go to
Daytime Running Lights (DRL) System Check
|
2
|
- Turn the ignition switch to the OFF position.
- Ensure that the Ambient Light Sensor does not have any obstruction.
- Connect a scan tool.
- Turn the ignition switch to the ON position. Do not start the
engine.
- Using the scan tool, inspect for any DTCs in the Body Control
Module (BCM).
Does the scan tool show any DTCs?
| --
| Go to
Diagnostic Trouble Code (DTC) List/Type
in Body Control System
|
Go to Step 3
|
3
| Move the
headlamp switch to the ON position.
Do the headlamps illuminate?
| --
|
Go to Step
4
| Go to
Daytime Running Lamps (DRL) Headlamps Inoperative
|
4
| Using the scan tool, read the Head Lamp Relay Feedback
status in the Body Control Module.
Does the scan tool show the status of ON?
| --
|
Go to Step 6
|
Go to Step
5
|
5
|
- Move the headlamp switch to the AUTO position.
- Turn the ignition switch to the OFF position.
- Disconnect the Body Control Module (BCM).
- Move the headlamp switch to the ON position.
- Using the J 35616
, connect a test lamp from terminal A11 of connector C2
at the BCM.
Does the test lamp illuminate?
| --
|
Go to Step
6
|
Go to Step 7
|
6
|
- Reconnect the BCM if disconnected in a previous step.
- Turn the ignition switch to the ON position. Do not start the
engine.
- Using the scan tool, read the Ambient Light Sensor voltage in
the the BCM.
- While monitoring the scan tool, cover the Ambient Light Sensor,
then induce a light source to the sensor.
Does the sensor voltage vary within the specified ranges?
| 4.7-2.2 V (DRL
on)
0.2-1.3 V (Headlamps on)
|
Go to Step
8
| Go to
Diagnostic System Check - Body Control System
in Body Controls
|
7
| Locate and Repair
the open in CKT 352 (WHT) between the underhood fuse block and the
BCM.
Is the repair complete?
| --
| Go to
Daytime Running Lights (DRL) System Check
| --
|
8
|
- Move the headlamp switch to the AUTO position.
- Using the scan tool, command the headlamps ON.
Does the headlamps illuminate?
| --
| Go to
Daytime Running Lights (DRL) System Check
|
Go to Step 9
|
9
| Replace the BCM. Refer to
Body Control Module Replacement
in Body Control System.
Is the repair complete?
| --
| Go to
Daytime Running Lights (DRL) System Check
| --
|