GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1999 🢒 Blazer - 4WD - RHD 🢒 Engine 🢒 Engine Controls - 4.3L 🢒 Cruise Control Cable Replacement

Removal Procedure

    Object Number: 373041 Size: SH
  1. Disconnect the cruise control cable clip from the brake booster.
  2. Disconnect the cruise control cable from the bracket located next to the alternator.
  3. Disconnect the cruise control cable conduit fitting from the round hole in the engine cable bracket.
  4. Disconnect the cruise control cable engine-end fitting from the nail-head stud on the throttle lever.

    5. Object Number: 7388 Size: SH
  5. Disconnect the cruise control cable fitting from the cruise control module.

    6. Object Number: 7384 Size: SH
  6. Disconnect the cruise control cable bead from the fitting on the cruise control module ribbon.
  7. Remove the cruise control cable from the vehicle.

Installation Procedure

    Object Number: 7384 Size: SH
  1. Remove and discard the plastic cable retainer.
  2. Install the cruise control cable to the vehicle.
  3. Connect the cruise control cable bead to the fitting on the cruise control module ribbon.

    4. Object Number: 7386 Size: SH
  4. Pull the cruise control cable until the cable is taut.

    5. Object Number: 7388 Size: SH
  5. Turn the cruise control cable at the engine-end fitting in order to straighten the cruise control module ribbon, as needed.
  6. Ensure that the ribbon is flat and vertical.
  7. Slide the cruise control cable conduit over the ribbon.
    8. • Install the tangs to the cruise control module housing.
    • Ensure that the tangs snap securely into place.
  8. Snap the cruise control cable engine-end fitting over the nail head stud on the throttle lever.

    9. Object Number: 373041 Size: SH
  9. Connect the cruise control cable conduit fitting to the round hole in the engine cable bracket.
  10. Ensure that the tabs snap securely into the hole.
  11. Connect the cruise control cable to the bracket located next to the alternator.
  12. Connect the cruise control cable clip to the brake booster.

    13. Object Number: 296591 Size: SH
  13. Push the cable adjuster plunger into the locked position (2). Ensure that the white paint area is no longer visible.

    14.    Important: Secure all of the components of the accelerator and the cruise control cables as specified. Ensure that the throttle linkage operates freely without binding between the idle position and the wide open throttle.

    • The lash should automatically be set at 0.0 mm to 1.0 mm (0.0 in to 0.04 in) by the adjuster.
    • If an adjustment is required, refer to Cruise Control Cable Adjustment .