GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1999 🢒 Blazer - 4WD - RHD 🢒 Body and Accessories 🢒 Interior Trim 🢒 Headlining Trim Panel Replacement

Removal Procedure

    Object Number: 392798 Size: SH
  1. Remove the sunroof console, if equipped. Refer to Driver Information Center Replacement in Instrument Panel, Gauges and Console.
  2. Remove the dome lamp. Refer to Dome Lamp Replacement in Lighting Systems.
  3. Remove the sunroof opening trim (if equipped) by grasping it at the edge and pulling it away from the headliner.
  4. Remove the coat hooks. Refer to Coat Hook Replacement.
  5. Remove the assist handles. Refer to Assist Handle Replacement.
  6. Remove the sunshades and the retainers. Refer to Sunshade Replacement.
  7. Remove the windshield garnish moldings. Refer to Garnish Molding Replacement - Windshield Pillar.
  8. Remove the body lock pillar trim panels (four-door models only). Refer to Garnish Molding Replace - Side Door Lock Pillar.

    9. Object Number: 395322 Size: SH
  9. Remove the upper seat belt anchor bolts (two-door models only).

    10. Object Number: 392833 Size: SH
  10. Remove the inside air temperature sensor grille.
  11. Remove the body side trim panel. Refer to Trim Panel Replacement - Body Side.
  12. Remove the rear upper garnish molding. Refer to Garnish Molding Replacement - Rear Upper.
  13. Remove the headliner from the vehicle.

Installation Procedure

    Object Number: 392833 Size: SH
  1. Install the headliner to the vehicle. New headliners must be pierced in order to accommodate actual vehicle accessories.
  2. Install the rear upper garnish molding. Refer to Garnish Molding Replacement - Rear Upper.
  3. Install the upper body side panel trim. Refer to Trim Panel Replacement - Body Side.
  4. Install the inside air temperature sensor grille.

    5. Object Number: 395322 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the rear seat upper seat belt anchor bolts (two-door models only).

    6. Tighten
    Tighten the bolts to 70 N·m (52 lb ft).


    Object Number: 392798 Size: SH
  6. Install the body lock pillar trim panels (four-door models only). Refer to Garnish Molding Replace - Side Door Lock Pillar.
  7. Install the windshield garnish moldings. Refer to Garnish Molding Replacement - Windshield Pillar.
  8. Install the sunshades and the retainers. Refer to Sunshade Replacement.
  9. Install the assist handles. Refer to Assist Handle Replacement.
  10. Install the coat hooks. Refer to Coat Hook Replacement.
  11. Install the sunroof opening trim (if equipped) by carefully pressing it into place.
  12. Install the dome lamp (if equipped). Refer to Dome Lamp Replacement in Lighting Systems.
  13. Install the overhead or sunroof console (if equipped). Refer to Driver Information Center Replacement in Instrument Panel, Gauges and Console.