DTC P1572 TCS Active Circuit Low Voltage Too Long 5.7L, VIN P Only
Circuit Description
Important: Refer to Automatic Transmission Controls - Cell 39, for applicable schematic.
The PCM receives an input signal from the traction control system (TCS) indicating that a traction control event is occuring. The Battery Positive signal during normal operation becomes zero volts during the tractioin control event. The PCM inhibits upshits, downshifts, and TCC operation during a traction control event.
If the PCM detects an active traction control circuit in Park and Neutral, in 2 consecutive ignition cycles, then DTC P1572 sets. DTC P1572 is a type B DTC.
Conditions for Setting the DTC
| • | No TFP Val Position Sw DTC P1810 |
| • | The transmission is in Park or Neutral. |
| • | The traction control is active. |
| • | All conditions are satisfied for 6.4 seconds. |
Action Taken When the DTC Sets
| • | If the TCS is active, then the TCC is OFF. |
| • | The PCM inhibits 4th gear if in hot mode. |
| • | The PCM freezes shift adapts. |
| • | The PCM illuminates the Malfunction Indicator Lamp (MIL). |
Conditions for Clearing the MIL/DTC
| • | The PCM turns OFF the MIL after three consecutive ignition cycles without a failure reported. |
| • | A scan tool can clear the DTC from the PCM history. The PCM clears the DTC from the PCM history if the vehicle completes 40 warm-up cycles without a failure reported. |
| • | The PCM cancels the DTC default actions when the fault no longer exists and the ignition is OFF long enough in order to power down the PCM. |
Diagnostic Aids
| • | Inspect the wiring for any poor electrical connections at the PCM. Inspect the wiring at the TCC brake switch. Look for the following problems: |
| - | A bent terminal |
| - | A backed out terminal |
| - | A damaged terminal |
| - | Poor terminal tension |
| - | A chafed wire |
| - | A broken wire inside the insulation |
| • | When diagnosing for an intermittent short or an open, massage the wiring harness while watching the test equipment for a change. |
Test Description
The item numbers below refer to the step numbers on the diagnostic table.
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Was the Powertrain On-Board Diagnostic (OBD) System Check performed? | -- | Go to Powertrain On Board Diagnostic (OBD) System Check , Section 6. | |
2 |
Important: Before clearing the DTCs, use the scan tool in order to record the Freeze Frame and Failure Records for reference. The Clear Info function will erase the data. Does the scan tool display the Traction Control as Active? | -- | Go to Diagnostic Aids | |
3 |
Does the scan tool still display the Traction Control as Active? | -- | Refer to ABS/TCS Diagnostic System Check, Section 5 | Go to Step 4 |
4 | Replace the PCM. Refer to Powertrain Control Module Replacement/Programming , Section 6. Is the replacement complete? | -- | -- | |
5 |
Has the test run and passed? | -- | System OK |
