Special Tools

J 45012 Holding Fixture

1. Raise and support the vehicle.
2. Remove the exhaust system.
3. Remove the drive shaft.
4. Support the transmission with a suitable jack.
5. Remove the transmission mount assembly.



6. Install the propeller shaft flange holding fixture J 45012 .

Caution: Do not reuse the flange nut. Reusing the flange nut may cause damage to the transmission.

7. Remove and discard the propeller shaft flange nut.
8. Remove the propeller shaft flange.



9. Remove the case extension housing bolts.
10. Remove the case extension housing.
11. Remove the case extension housing seal.

1. Install the case extension housing seal.
2. Install the case extension housing.
3. Install by hand the case extension housing bolts.

Caution: Refer to Fastener Caution in the Preface section.




4. Secure the case extension housing bolts in the specified sequence and tighten to 50 N·m (37 lb ft).



5. Install the prop shaft flange.

Caution: Stake the flange nut onto the output shaft. Use the two staking grooves on the shaft to locate the staking points. Failure to stake the flange nut may result in damage to the transmission.

Note: Use a NEW propeller shaft flange nut.

6. Install the NEW propeller shaft flange nut and tighten to 105 N·m (77 lb ft).
7. Remove the propeller shaft flange holding fixture J 45012 .
8. Install the transmission mount assembly.
9. Remove the transmission jack.
10. Install the drive shaft.
11. Install the exhaust system.
12. Lower the vehicle.