Radio Replacement Chevrolet

1. Disable the SIR system. Refer to Disabling the SIR System in SIR.

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

2. Disconnect the negative battery cable.
3. Remove the IP cluster trim plate. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement in Instrument Panel, Gauges and Console.



4. Remove the screws (1).
5. Pull the radio (2) out from the instrument panel (3).
6. Disconnect the electrical connections.
7. Disconnect the antenna lead connections.
8. Remove the radio (2) from the vehicle.

1. Connect the electrical connections to the radio (2).
2. Connect the antenna lead connections to the radio.
3. Install the radio (2) to the instrument panel (3).
4. Install the screws (1) to the instrument panel.
5. Install the IP cluster trim plate. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement in Instrument Panel, Gauges and Console.
6. Connect the negative battery cable.
7. Enable the SIR system. Refer to Enabling the SIR System in SIR.

Radio Replacement Pontiac

1. Disable the SIR system. Refer to Enabling the SIR System in SIR.

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

2. Disconnect the negative battery cable.
3. Remove the accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement in Instrument Panel, Gauges and Console.



4. Remove the screws (2).
5. Pull the radio (3) out from the instrument panel.
6. Disconnect the electrical connections (4).
7. Disconnect the antenna lead connections (1).
8. Remove the radio (3) from the vehicle.

1. Connect the electrical connections (4) to the radio (3).
2. Connect the antenna lead connections (1) to the radio (3).
3. Install the radio (3) to the instrument panel.
4. Install the screws (2) to the instrument panel.
5. Install the accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement in Instrument Panel, Gauges and Console.
6. Connect the negative battery cable.
7. Enable the SIR system. Refer to Enabling the SIR System in SIR.