Step
| Action
| Normal Result(s)
| Abnormal Result(s)*
|
1
| Turn the ignition switch to OFF for 5 seconds.
| The engine
is off.
| --
|
2
| Observe the THEFT SYSTEM indicator.
| The THEFT SYSTEM indicator
is illuminated.
| --
|
3
| Turn the ignition switch to RUN.
| The SDL Monitor Mode displays the following settings:
Instrument Cluster to PCM
| • | The VTD Moding function is NOT SET. |
| • | The Reverse Rotate function is INACTIVE. |
| • | The VTD Password function indicates NOT RECEIVE. |
PCM to Instrument Cluster
| • | The VTD Acknowledge function indicates NO. |
| • | The VTD Tamper function is INACTIVE. |
| • | The Reference Sync function indicates NOT SYNC. |
| --
|
4
| For automatic transaxle, place the gear selector in PARK.
For manual transaxle, depress the clutch pedal in order to close the
clutch start switch.
| The THEFT SYSTEM indicator is illuminated.
| --
|
5
| Turn the ignition switch to START.
|
| • | The SDL Monitor Mode displays the following settings: |
Instrument Cluster to PCM
| • | The VTD Moding function is NOT SET. |
| • | The Reverse Rotate function is ACTIVE. |
| • | The VTD Password function indicates NOT RECEIVE. |
PCM to Instrument Cluster
| • | The VTD Acknowledge function indicates NO. |
| • | The VTD Tamper function is INACTIVE. |
| • | The Reference Sync function indicates NOT SYNC. |
| --
|
6
| After the engine starts, turn the ignition switch to RUN.
|
| • | The THEFT SYSTEM indicator turns off. |
| • | The SDL Monitor Mode displays the following settings: |
Instrument Cluster to PCM
| • | The VTD Moding function is SET. |
| • | The Reverse Rotate function is INACTIVE. |
| • | The VTD Password function indicates RECEIVE. |
PCM to Instrument Cluster
| • | The VTD Acknowledge function indicates YES. |
| • | The VTD Tamper function is INACTIVE. |
| • | The Reference Sync function indicates SYNC. |
| --
|
7
| Turn the ignition switch to OFF.
|
| • | There is no UART communication. |
| --
|
* Refer to the appropriate symptom diagnostic
table for the applicable abnormal result.
|
