Removal Procedure
- Pull the inside handle
to the full open position.
- Press on the inside handle bezel.
- Use a flat-bladed tool in order to pry the handle bezel from the
top.
- Pull the bezel upward.
- On the front door only,
disconnect the door lock switch wire harness (2), if equipped.
- Remove the inside bezel (1).
Installation Procedure
- On the front door only,
connect the door lock switch wire harness (2), if equipped.
- Pull the inside handle to the full open position.
- Insert the front tab (1)
on the inside bezel to the locating notch. This notch is located behind the
front edge of the opening in the door trim panel.
- Push downward on the inside bezel in order to insert the lower
tab (2) behind the lower edge of the door trim panel.
- Insert the rearmost lowest tab (3) of the inside bezel
to the edge of the door trim panel.
- Snap the top 2 tabs (4) on the inside bezel into position.