Caution: Be careful when you handle a sensor. Do not strike or jolt a sensor.
Before applying power to a sensor:
⢠| Remove any dirt, grease, etc. from the mounting surface. |
⢠| Position the sensor horizontally on the mounting surface. |
⢠| Point the arrow on the sensor toward the front of the vehicle. |
⢠| Tighten all of the sensor fasteners and sensor bracket fasteners
to the specified torque value. |
Failure to follow the correct procedure could cause air bag deployment,
personal injury, or unnecessary SIR system repairs.
Removal Procedure
- Disable the SIR system.
Refer to
Disabling the SIR System
.
- Remove the hood closeout filler panel. Refer to
Hood Close Out Filler Replacement
in Body Front End.
- Remove the connector position assurance (CPA) from the wiring
harness connector to the inflatable restraint front end discriminating sensor.
- Disconnect the wiring
harness connector from the sensor.
- Remove the mounting bolts (2)
from the sensor (1).
- Remove the sensor (1) from the hood latch support bracket (3).
Installation Procedure
- Install the inflatable
restraint front end discriminating sensor (1) to the hood latch support
bracket (3).
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the mounting
bolts (2) to the sensor.
Tighten
Tighten the bolts to 10 NĀ·m (89 lb in).
- Connect the wiring harness
connector to the sensor.
- Install the CPA to the
wiring harness connector.
- Install the hood closeout filler panel. Refer to
Hood Close Out Filler Replacement
in Body Front End.
- Enable the SIR system. Refer to
Enabling the SIR System
.