For 1990-2009 cars only
Removal Procedure
- Set the parking brake.
- Remove the retainer.
- Remove the pushrod.
- Remove the stoplamp switch connector and the actuator.
- Remove the nut that secures the brake pedal pin bolt to the support.
- Remove the brake pedal pin bolt and the brake pedal pin.
- Remove the bushings and the return spring from the pedal.
- Inspect the bushings for wear or deterioration. Replace the bushings if necessary.
- Remove the brake pedal, and cover, if required.
Installation Procedure
- Install a new brake pedal cover, if required.
- Lubricate the pivot points and both ends of the return spring with GM lubricant P/N 1050109.
- Install the brake pedal with the pin and the bushings.
- Install the brake pedal pin bolt.
- Install the stoplamp switch actuator.
- Install the pushrod.
- Install the retainer.
- Install the return spring to the pedal.
- Install the stoplamp switch connector to the actuator.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the brake pedal pin nut to 10 N·m (89 lb in).
