Tools Required

J 41371 Reluctor Wheel Remover

Caution: Before servicing any electrical component, the ignition and start switch must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.

1. Disconnect the battery negative cable.



2. Remove the crankshaft balancer from the crankshaft. Refer to Crankshaft Balancer Replacement .



3. Remove the water pump from the engine block. Refer to Water Pump Replacement in Engine Cooling.



4. Remove the engine front cover from the engine block. Refer to Engine Front Cover Replacement .



5. Use the J 41371 in order to remove the reluctor ring from the crankshaft.

Important: Replace the crankshaft position sensor whenever the crankshaft position reluctor ring is replaced.

1. Install the crankshaft position reluctor ring on to the crankshaft.



2. Install the engine front cover to the engine block. Refer to Engine Front Cover Replacement .



3. Install the water pump to the engine block. Refer to Water Pump Replacement in Engine Cooling.



4. Install the crankshaft balancer to the crankshaft. Refer to Crankshaft Balancer Replacement .
5. Connect the battery negative cable.