1. Disconnect the seat belt/lamps alarm module.
2. Install a fused jumper wire at the seat belt/lamps alarm module connector, from cavity D 2 to cavity C2. Refer to Using Fused Jumper Wires in Wiring Systems.
3. Turn the ignition switch to the RUN position.

Did the seat belt indicator illuminate?

--

Go to Step 4

Go to Step 2

1. Remove the fused jumper wire.
2. Disconnect the instrument cluster connector.
3. Use a J 39200 DMM in order to measure the resistance between the seat belt /lamps alarm connector, cavity C2, and the instrument cluster connector, cavity 30.

Did the resistance measure greater than the specified value?

1.0 ohms

Go to Step 3

Go to Step 5

Repair the open in CKT 234 (YEL) between the instrument cluster connector, cavity 30 and the seat belt/lamps alarm module connector, cavity C2.

Did you complete the repair?

--

System OK

--

Replace the seat belt/lamps alarm module.

Did you complete the repair?

--

System OK

--

Replace the instrument cluster.

Did you complete the repair?

--

System OK

--