Fuel Heater Replacement EFI/MFI

1. Remove the fuel tank filler cap.
2. Remove the air cleaner assembly.



3. Open the air bleed valve on top of the fuel manager/filter in order to release any of the pressure in the fuel supply system.



4. Remove the mounting bolts that connect the fuel manager/filter to the intake manifold.



5. Disconnect the wiring harnesses and fuel hoses.
6. Remove the fuel manager/filter by lifting straight up.



7. Remove the fuel heater threaded nut by turning counter clock wise. Use a hand pressure or a strap wrench in order to remove the fuel heater threaded nut.
8. Disconnect the fuel heater connector.
9. Remove the fuel heater from the filter housing.
10. Clean the fuel heater to housing sealing surfaces.

1. Install the cap seal into the filter housing.
2. Install the fuel heater.

Notice: Replacement components must be the correct part number for the application. Components requiring the use of the thread locking compound, lubricants, corrosion inhibitors, or sealants are identified in the service procedure. Some replacement components may come with these coatings already applied. Do not use these coatings on components unless specified. These coatings can affect the final torque, which may affect the operation of the component. Use the correct torque specification when installing components in order to avoid damage.

3. Install the fuel heater threaded nut.

Tighten
Tighten the fuel heater securely by hand.

4. Reconnect fuel heater connector.



5. Position the fuel manager/filter to the intake manifold.



6. Connect the wiring harnesses and fuel hoses.
7. Install the mounting bolts that connect the fuel manager/filter to the intake manifold.

Tighten
Tighten the mounting bolts to 25 N·m (18 lb ft).

8. Bleed the air from the fuel manager/filter if necessary (Refer to Fuel Feed Pipe and Return Pipe Purging ).
9. Install the air cleaner assembly.
10. Install the fuel tank filler cap.