Step | Action | Value(s) | Yes | No | ||||
|---|---|---|---|---|---|---|---|---|
DEFINITION: The Driver Information Center DOOR AJAR message is always on or always off. | ||||||||
1 | Has the Instrument Cluster Diagnostic System Check been performed? | -- | ||||||
2 | Install a scan tool and establish communications with the LH door control module. Does the scan tool communicate with the LDCM? | -- | ||||||
3 |
Does the scan tool indicate the door ajar input as open and closed? | -- | ||||||
4 | Establish scan tool communications with the RH door control module. Does the scan tool communicate with the RDCM? | -- | ||||||
5 |
Does the scan tool indicate the door ajar input as open and closed? | -- | ||||||
6 | Disconnect the door latch connector C2. Does the scan tool indicate the door ajar input closed? | -- | ||||||
7 | Connect a fused jumper wire from the door latch connector C2,
Does the scan tool indicate the door ajar input open? | -- | ||||||
8 | Connect a fused jumper wire from the door latch connector C2,
Does the scan tool indicate the door ajar input open? | -- | ||||||
9 | Inspect and repair the short to ground in circuit,
If ok replace the DCM. Refer to Door Control Module Replacement . Is the repair complete? | -- | -- | |||||
10 | Inspect and repair the open or high resistance condition in circuit,
If ok replace the DCM. Refer to Door Control Module Replacement . Is the repair complete? | -- | -- | |||||
11 | Repair the open or high resistance condition in circuit 150. Is the repair complete? | -- | -- | |||||
12 | Replace the door latch. Refer to Door Lock Replacement . Is the repair complete? | -- | -- | |||||
13 | Replace the IPC. Refer to Instrument Cluster Replacement . Is the repair complete? | -- | -- | |||||
