GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1999 🢒 Corvette 🢒 Steering 🢒 Power Steering System 🢒 Power Steering Hoses Replacement

Removal Procedure
  1. Place a drain pan under the vehicle.
  2. Disconnect the power steering cooler hose from the reservoir and drain the fluid.

    3. Object Number: 65356 Size: SH
  3. Remove the power steering gear inlet hose (2) from the power steering pump (1).
  4. Remove the power steering gear inlet hose from the power steering gear.

Installation Procedure

    Object Number: 65356 Size: SH
  1. Connect the power steering gear inlet hose (2) to the power steering pump (1).

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Connect the power steering gear inlet hose to the power steering gear.

    3. Hold the power steering gear inlet hose against the power steering gear while tightening the hose fitting.

    Tighten
    Tighten the power steering gear inlet hose to 27 N·m (20 lb ft).

  3. Connect the power steering cooler hose and clamp to the reservoir.
  4. Remove the drain pan. Refill the power steering fluid reservoir and bleed the power steering system. Refer to Power Steering System Bleeding .