DEFINITION: The wiper/washer system works only in HI mode setting.

Were you sent here from the Wiper/Washer System Check?

--

Go to Step 2

Go to Wiper/Washer System Check

1. Disconnect the connector C219.
2. Turn the wiper switch to the LO position.
3. Connect a DMM between terminal C and terminal A of connector C219 leading towards the wiper switch.
4. Measure the wiper switch for continuity between terminal C and terminal A of connector C219 with the wiper switch in the LO position.

Is continuity present across the wiper switch when moved to the LO position?

--

Go to Step 3

Go to Step 9

1. Wiper switch still in the LO position.
2. Connect a DMM between terminal C and terminal B of connector C219 leading towards the wiper switch.
3. Measure the resistance through the wiper switch.

Is the resistance within the specified values?

23-25 Kohms

Go to Step 4

Go to Step 9

1. Reconnect the connector C219.
2. Disconnect the wiper motor connector.
3. Turn the ignition switch to the ON position.
4. Turn the wiper switch to the LO position.
5. Connect a DMM between terminal E of the wiper motor connector and ground.
6. Measure the voltage.

Is the voltage within the specified values?

10.0-14.0V

Go to Step 6

Go to Step 5

Repair an open in CKT 95.

Is the repair complete?

--

Go to Wiper/Washer System Check

--

1. Ignition switch still in the ON position.
2. Wiper switch still in the LO position.
3. Connect a DMM between terminal D of the wiper motor connector and ground.
4. Measure the voltage.

Is the voltage within the specified values?

10.0-14.0V

Go to Step 8

Go to Step 7

Repair an open in CKT 91.

Is the repair complete?

--

Go to Wiper/Washer System Check

--

Replace the wiper motor assembly. Refer to Windshield Wiper Motor Replacement .

Is the repair complete?

--

Go to Wiper/Washer System Check

--

Replace the wiper/washer switch. Refer to Windshield Wiper and Washer Switch Replacement .

Is the repair complete?

--

Go to Wiper/Washer System Check

--