DEFINITION: The wipers do not delay or delay time is incorrect.

Were you sent here from the Wiper/Washer System Check?

--

Go to Step 2

Go to Wiper/Washer System Check

1. Disconnect the wiper washer switch connector C219.
2. Set the wiper switch in the INT position.
3. Using a DMM set to the ohms scale, measure the resistance through the wiper/washer switch from terminal C of connector C219 to terminal A.
4. Move the wiper switch thorough the entire delay range, one notch at a time.

Is the resistance within the specified values?

39-690 Kohms

Go to Step 4

Go to Step 3

Replace the wiper/washer switch. Refer to Windshield Wiper and Washer Switch Replacement .

Is the repair complete?

--

Go to Wiper/Washer System Check

--

1. Set the wiper switch in the INT position.
2. Using a DMM set to the ohms scale, measure the resistance through the wiper/washer switch from terminal C of connector C219 to terminal B.

Is the resistance within the specified values?

23-25 Kohms

Go to Step 5

Go to Step 3

1. Reconnect the wiper/washer switch connector C219.
2. Disconnect the wiper motor connector.
3. Turn the ignition switch to the ON position.
4. Set the wiper switch in the INT position.
5. Connect a DMM between the wiper motor connector terminal E and ground.
6. Move the wiper switch thorough the entire delay range, one notch at a time.
7. Measure the voltage.

Is the voltage within the specified values?

10.0-14.0V

Go to Step 7

Go to Step 6

Repair the open in CKT 95.

Is the repair complete?

--

Go to Wiper/Washer System Check

--

Replace the wiper motor assembly. Refer to Windshield Wiper Motor Replacement .

Is the repair complete?

--

Go to Wiper/Washer System Check

--