GM Service Manual Online
For 1990-2009 cars only

Horns Always On

Step

Action

Value(s)

Yes

No

1

Were you sent here from the Horns Diagnostic System Check?

--

Go to Step 2

Go to Diagnostic System Check - Horns

2

  1. Disconnect the BCM connector C1.
  2. Turn the ignition key to the ON position.

Do the horns sound?

--

Go to Step 3

Go to Step 5

3

  1. Remove the HORN #36 Micro Relay from the underhood electrical center.
  2. Connect a DMM between the BCM connector C1 terminal B10 and ground.
  3. Check CKT 28 for continuity to ground at the BCM connector C1 terminal B10.

Is CKT 28 continuous to ground?

--

Go to Step 4

Go to Step 6

4

Caution: When you are performing service on or near the SIR components or the SIR wiring, you must disable the SIR system. Refer to Disabling the SIR System. Failure to follow the correct procedure could cause air bag deployment, personal injury, or unnecessary SIR system repairs.

  1. Remove the driver's side inflator module from the steering wheel.
  2. Disconnect the horn brush slip ring connector inside the steering wheel.
  3. DMM still connected between the BCM connector C1 terminal B10 and ground.

Is CKT 28 continuous to ground?

--

Go to Step 10

Go to Step 9

5

  1. Reconnect the BCM connector C1.
  2. Turn the ignition key to the ON position

Are the horns pulsating on/off simulating theft deterrent mode?

--

Go to Diagnostic System Check - Horns

Go to Step 11

6

  1. HORN #36 Micro Relay still removed from the underhood electrical center.
  2. Turn the ignition key to the ON position.

Are the horns sounding continuously?

--

Go to Step 7

Go to Step 8

7

Repair a short to battery power in CKT 29.

Is the repair complete?

--

Go to Diagnostic System Check - Horns

--

8

Replace the HORN #36 Micro Relay. Refer to Horn Relay Replacement .

Is the repair complete?

--

Go to Diagnostic System Check - Horns

--

9

Replace the Horn Switch Assembly. Refer to Horn Switch Replacement - On Vehicle .

Is the repair complete?

--

Go to Diagnostic System Check - Horns

--

10

Repair short to ground in CKT 28.

Is the repair complete?

--

Go to Diagnostic System Check - Horns

--

11

Replace and reprogram the BCM according to vehicle RPO configuration. Refer to Body Control Module Replacement .

Is the repair complete?

--

Go to Diagnostic System Check - Horns

--