GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1999 🢒 Corvette 🢒 Body and Accessories 🢒 Horns 🢒 Horn Replacement

Removal Procedure

    Object Number: 65137 Size: SH
  1. Remove the RH front fascia lower closeout panel. Refer to Front Bumper Fascia Lower Close Out Panel Replacement in Bumpers.
  2. Disconnect the electrical connector from the horn assembly.

    3. Object Number: 65138 Size: SH
  3. Remove the bolt mounting the horn assembly to the skid bar assembly.
  4. Remove the horn assembly from the vehicle.

Installation Procedure

    Object Number: 65138 Size: SH
  1. Install the horn assembly to the vehicle.

    2. Position the aligning tab on the horn assembly to the skid bar.

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the bolt mounting the horn assembly to the skid bar.

    3. Tighten
    Tighten the horn assembly mounting bolt to 25 N·m (18 lb ft).


    Object Number: 65137 Size: SH
  3. Connect the electrical connector to the horn assembly.
  4. Install the RH front fascia lower closeout panel. Refer to Front Bumper Fascia Lower Close Out Panel Replacement in Bumpers.