Important: The Tire Pressure Monitor (TPM) system uses the same receiver as the Remote Function Actuation (RFA) system. The service replacement receiver must be programmed to accept both the TPM sensors and the keyless entry transmitters. Refer to Tire Pressure Monitoring Sensor Programming and Transmitter Programming/Synchronization in Keyless Entry.

1. Turn the ignition to OFF.
2. Remove the left rear compartment insulator (1).



3. Gently pull on the retainer at the back side of the receiver (1).
4. Pull out the receiver (1) only enough to expose the connector (2).
5. Disconnect the receiver connector (2).

1. Connect the receiver connector (2).
2. Line up the receiver (1) with the slots on the retainer.
3. Snap the receiver (1) into place on the retainer.



4. Install the left rear compartment insulator (1).
5. Program the TPM sensors. Refer to Tire Pressure Monitoring Sensor Programming in Tire Pressure Monitor.
6. Program the keyless entry transmitters. Refer to Transmitter Programming/Synchronization .