Removal Procedure
- Remove the instrument panel (I/P) lower insulator panel - RH. Refer to Instrument Panel Insulator Panel Replacement in Instrument Panel, Gauges and Console.
- Disconnect the electrical connector from the vacuum control solenoid valve.
- Disconnect the vacuum harness connector from the vacuum control solenoid valve.
- Remove the vacuum control solenoid valve retaining screws.
- Remove the control solenoid.
Pull the control solenoid straight down to release the tab from the slot in the HVAC module case.
Installation Procedure
- Align the vacuum control solenoid valve tab to the slot in the HVAC module case, then push up to seat the control solenoid.
- Install the vacuum control solenoid valve retaining screws.
- Connect the vacuum harness connector to the vacuum control solenoid valve.
- Connect the electrical connector to the vacuum control solenoid valve.
- Install the instrument panel (I/P) lower insulator panel - RH. Refer to Instrument Panel Insulator Panel Replacement in Instrument Panel, Gauges and Console.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the vacuum control solenoid valve retaining screws to 1.5 N·m
(13 lb in).
