Component Description

Inflatable Restraint Sensing and Diagnostic Module

The inflatable restraint sensing and diagnostic module (SDM) performs the following functions in the SIR system:

The SDM connects to the SIR wiring harness using the following connector(s):

The 18-way connector provides power, ground, and all the required interfaces for the frontal air bag deployment loops.

The SDM receives power when the ignition switch is in the RUN position.

Inflatable Restraint Sensing and Diagnostic Module (PSIR)

The inflatable restraint sensing and diagnostic module (SDM) performs the following functions in the SIR system:

The SDM connects to the SIR wiring harness, the inflatable restraint IP module switch and the inflatable restraint IP module LED using the following connector(s):

The 18-way connector provides power, ground, and all the required interfaces for the frontal air bag deployment loops.

The 6-way connector provides power, ground, and all the required interfaces for the SDM and the inflatable restraint IP module LED.

The 2-way connector provides the required interfaces between the inflatable restraint IP module switch and the inflatable restraint IP module LED.

The SDM and the inflatable restraint IP module receive power when the ignition switch is in the RUN position.

AIR BAG Warning Lamp

The AIR BAG warning lamp is represented by an icon graphic. Ignition voltage is applied to the AIR BAG warning lamp when the ignition switch is turned to the RUN position. The inflatable restraint sensing and diagnostic module (SDM) controls the lamp by communicating with the instrument cluster over the Class 2 serial data circuit. The SIR system uses the AIR BAG warning lamp to do the following:

The AIR BAG warning lamp is the key to driver notification of SIR system malfunctions. Refer to the SIR diagnostic system check for proper lamp operation.

Inflatable Restraint Steering Wheel Module Coil

The inflatable restraint steering wheel module coil consists of two or more current-carrying coils. The inflatable restraint steering wheel module coil attaches to the steering column. Two of the current-carrying coils allow rotation of the steering wheel while maintaining continuous contact of the driver frontal deployment loop to the inflatable restraint steering wheel module.

There is a shorting bar on the yellow 2-way connector near the base of the steering column that connects the inflatable restraint steering wheel module coil to the SIR wiring harness. The shorting bar shorts the circuits to the inflatable restraint steering wheel module coil and inflatable restraint steering wheel module during the disconnection of the yellow 2-way connector. The shorting of the inflatable restraint steering wheel module coil and inflatable restraint steering wheel module circuitry will help prevent unwanted deployment of the air bag when servicing the steering column or other SIR system components.

Inflator Modules

The inflator modules consist of an inflatable bag and an inflator. An inflator consists of a canister of gas-generating material and an initiating device. The initiator is part of the deployment loop. When the vehicle is in a frontal crash of sufficient force, the inflatable restraint sensing and diagnostic module (SDM) causes current to flow through the frontal air bag deployment loops. Current passing through the initiator ignites the material in the inflator module. The gas produced from this reaction rapidly inflates the air bag.

There is a shorting bar on the inflatable restraint steering wheel module side of the upper steering column connector that connects the inflatable restraint steering wheel module coil to the inflatable restraint steering wheel module. The shorting bar shorts across the inflatable restraint steering wheel module circuits during the disconnection of the upper steering column connector. The shorting of the inflatable restraint steering wheel module circuitry will help prevent unwanted deployment of the air bag when servicing the inflatable restraint steering wheel module, the steering column or other SIR system components.

There is a shorting bar on the inflatable restraint IP module connector that connects to the SIR wiring harness. The shorting bar shorts across the inflatable restraint IP module circuits during the disconnection of the inflatable restraint IP module connector. The shorting of the inflatable restraint IP module circuitry will help prevent unwanted deployment of the air bag when servicing the inflatable restraint IP module, the instrument panel or other SIR system components.

Steering Column

The steering column is energy absorbing. The steering column can compress during a frontal crash in order to decrease the chance of injury to the driver.

Knee Bolster

The knee bolsters absorb energy and control the forward movement of the vehicle's front seat occupants during a frontal crash, by limiting leg movement.

Inflatable Restraint IP Module Switch (PSIR)

The inflatable restraint IP module (PSIR suppression) switch is a manual 2-position key switch located on the right hand side of the IP compartment. This switch gives the vehicle operator the ability to enable or disable the inflatable restraint IP module (Passenger Front Air Bag) deployment should the vehicle be involved in a severe frontal collision. The vehicle operator may choose to disable the inflatable restraint IP module if there is no occupant in the front seat, or if there is a child in a rear-facing child seat in the front seat.

The manual key-switch operates in two positions. When the key is vertical, the switch is in the OFF position and the inflatable restraint IP module is in the suppressed (disabled) state. In the suppressed state, the inflatable restraint IP module will not deploy in the event of a severe frontal collision. When the key is horizontal, the switch is in the ON position and the inflatable restraint IP module is in the nonsuppressed (enabled) state. In the nonsuppressed state, the inflatable restraint IP module will deploy in the event of a severe frontal collision. This switch interfaces directly with the inflatable restraint sensing and diagnostic module (SDM) and the inflatable restraint IP module PSIR suppression LED. The SDM senses the state of the inflatable restraint IP module PSIR suppression switch. When the switch is in the ON position, the SDM enables possible deployment of the inflatable restraint IP module. When the switch is in the OFF position, the SDM disables or inhibits possible deployment of the inflatable restraint IP module and illuminates the inflatable restraint IP module PSIR suppression LED.

Inflatable Restraint IP Module LED (PSIR)

The inflatable restraint IP module PSIR suppression LED is located on the IP accessory trim plate in front of the IP console. When the manual 2-position key on the inflatable restraint IP module PSIR suppression switch is in the OFF position, the LED will illuminate to advise the vehicle operator that the inflatable restraint IP module has been disabled and will not deploy in the event of a severe frontal collision. The LED will turn OFF whenever the manual 2-position key on the inflatable restraint IP module PSIR suppression switch is in the ON position. The LED will also dim to a lower intensity when the head lamp switch is turned ON. When the head lamp switch is OFF the LED will illuminate to full intensity.

Definitions

Air Bag: An inflatable cloth cushion designed to deploy in certain frontal or side impact crashes. The air bags distribute the impact load more evenly over the occupant's head and torso in order to supplement the safety belt protection.

Asynchronous: An event that can occur at any time without a warning and without falling within a defined time period.

B+: The battery voltage available at the time of the indicated measurement. With the ignition in ON and the engine stopped, the voltage is usually 11.5-12.5 V. With the engine at idle, the voltage may be 14.0-16.0 V. During engine cranking, the voltage can be as low as 10.0 V.

Bulb Test: The Instrument Panel Cluster (IPC) will flash the air bag warning lamp indicator 7 times when the ignition switch is turned from OFF to RUN. The inflatable restraint sensing and diagnostic module (SDM) then commands the IPC to turn the warning indicator OFF through serial data communication. This indicates that there are no malfunctions in the SIR system. If a SIR system malfunction is present, the IPC flashes the warning indicator seven times and the SDM then commands the IPC to turn the warning lamp indicator ON. An IPC malfunction could prevent the IPC from flashing the indicator.

Class 2: A serial data communications protocol.

Continuous Monitoring Tests: The inflatable restraint Sensing and Diagnostic Module (SDM) continuously monitors the SIR system during each 60 millisecond interval. The IGNITION 1 voltage at the module must be within the normal operating voltage range for the continuous monitoring to occur. These tests follow the power-on tests.

Data Link Connector (DLC): The DLC electrically connects to many on-board computers and allows communication with an off-board computer such as a scan tool.

Datum Line: A base line parallel to the plane of the vehicle underbody or the frame. All vertical measurements originate from this base line.

Deploy: To inflate the air bag.

Deployment Loops: The circuits that supply the current to the inflator modules for air bag deployment.

Deployment Loop Voltage Out Of Range Test: This test is run during power-on and continuous monitoring diagnostics. The inflatable restraint Sensing and Diagnostic Module (SDM) performs this test in order to inspect for a short circuit to B+ or ground within the deployment loops. If the SDM detects a short circuit to voltage within a deployment loop, the resistance measurement test for that deployment loop will be not be run.

Deployment Loop Resistance Measurement Test: This test is run during power-on and continuous monitoring diagnostics. The inflatable restraint Sensing and Diagnostic Module (SDM) performs this test in order to inspect for proper deployment loop resistance. This test is run after the voltage out of range test as long as a short to B+ does not exist within the deployment loop.

Diagnostic Trouble Code (DTC): An alphanumeric designator used by the inflatable restraint Sensing and Diagnostic Module (SDM) in order to indicate specific SIR system malfunctions.

EEPROM (Electrically Erasable Programmable Read Only Memory): Memory that does not require power to the inflatable restraint Sensing and Diagnostic Module (SDM) in order to retain its contents.

Higher Priority Fault: Each DTC has an assigned priority based on its detectability with other DTCs present. The priority corresponds to the detectability of the malfunction only. This does not relate to the seriousness of the malfunction with respect to deployment or non deployment under any given condition.

Ignition Cycle: The operation of the ignition switch causes this cycle to occur. The inflatable restraint Sensing and Diagnostic Module (SDM) must first sense IGNITION 1 input greater than 9.0 V with the ignition switch in RUN. The IGNITION 1 input voltage must remain above 9.0 V for at least 10 seconds before turning the ignition switch to OFF.

Ignition 1: A B+ circuit receiving power with the ignition switch in the RUN position.

Inflatable Restraint IP Module: An assembly located on the RH of the IP consisting of an inflatable air bag, an inflator, and an initiator.

Inflatable Restraint IP Module LED (PSIR): An LED located on the IP accessory trim panel in front of the center console compartment, that advises the vehicle operator if the passenger air bag has been disabled.

Inflatable Restraint IP Module Switch (PSIR): A switch located in the RH side of the IP compartment, that the vehicle operator can set to either disable or enable the operation of the passenger air bag.

Inflatable Restraint Sensing and Diagnostic Module (SDM): The SIR control module that provides reserve energy to the deployment loops, deploys the air bags when required, and performs diagnostic monitoring of all SIR system components.

Inflatable Restraint Steering Wheel Module: An assembly located in the steering wheel hub consisting of an inflatable bag, an inflator, and an initiator.

Inflatable Restraint Steering Wheel Module Coil: An assembly of two or more current carrying coils mounted within the steering column hub. The assembly allows the rotation of the steering wheel while maintaining continuous electrical circuit contact. Two of the coils provide continuous contact of the driver deployment loop to the inflatable restraint steering wheel module.

Initiator: Located in the inflator module, the initiator initiates the chemical reaction that inflates the air bag when sufficient current flows through the component.

Normal Operating Voltage Range: 9.0-16.0 V when measuring between the inflatable restraint Sensing and Diagnostic Module (SDM) IGNITION POSITIVE VOLTAGE terminal and ground.

Power-on Tests: Tests that the inflatable restraint Sensing and Diagnostic Module (SDM) performs on the SIR system once per ignition cycle. These tests occur immediately after the module receives IGNITION 1 voltage, and before the continuous monitoring tests.

Scan Tool: An off-board computer that reads on-board computer diagnostic information through the use of a DLC.

Serial Data: The information communicated to an off-board computer using the DLC. Some of this data represents the status of the SIR system.

SIR: Supplemental inflatable restraint.

SIR Wiring Harness: The wires and connectors that electrically connect the components in the SIR system.

SOH: State Of Health

23 VLR: The 23 volt loop reserve. The energy supply that is internal to the inflatable restraint Sensing and Diagnostic Module (SDM).