DEFINITION: The wipers do not delay or the delay time is incorrect.

Did you review the Wiper Washer System Circuit Description and perforn the necessary inspections?

--

Go to Step 2

Go to Symptoms

1. Disconnect the windshield wiper/washer switch pigtail connector C219.
2. Set the windshield wiper/washer switch lever to the INT position.
3. Measure the resistance through the windshield wiper/washer switch from the connector terminals C to B.

Is the resistance within the specified values?

23-25K ohms

Go to Step 3

Go to Step 4

1. With the windshield wiper/washer switch lever in the INT position.
2. Measure the resistance through the windshield wiper/washer switch from the connector terminals C to A.
3. Turn the INT ADJ band through the following 5 positions:

•	position 1 (39K ohms)

•	position 2 (82K ohms)

•	position 3 (150K ohms)

•	position 4 (270K ohms)

•	position 5 (680K ohms)

Are the resistance measurements at or near the values listed?

--

Go to Step 5

Go to Step 4

Replace the windshield wiper/washer switch. Refer to Windshield Wiper and Washer Switch Replacement .

Is the repair complete?

--

Go to Step 7

--

Test and repair the the following circuits for an open or high resistance between the windshield wiper/washer switch connector C219 and the windshield wiper motor connector:

Did you find and correct the condition?

--

Go to Step 7

Go to Step 6

Replace the wiper motor assembly. Refer to Windshield Wiper Motor Replacement .

Is the repair complete?

--

Go to Step 7

--

Operate the system in order to verify the repair.

Did you correct the condition?

--

System OK

Go to Symptoms