Did you perform the IPC Diagnostic System Check?

--

Go to Step 2

Go to Diagnostic System Check - Instrument Cluster

1. Engine idling at normal operating conditions.
2. Observe the following gauges:

•

Fuel

•	Oil Pressure

•	Coolant Temperature

•

Voltage

Are all of the gauges functioning properly and not within the red zone?

--

Go to Step 3

Go to the Applicable Symptom Table

1. Install a scan tool.
2. Turn ON the ignition, with the engine OFF.
3. With a scan tool, select IPC special functions and command the CHECK GAGES indicator ON and OFF.

Does CHECK GAGES indicator turn ON and OFF with each command?

--

System OK

Go to Step 4

Inspect the CHECK GAGES bulb for and open. Refer to Instrument Cluster Indicator Lamp Replacement .

Did you find and correct the condition?

--

Go to Step 6

Go to Step 5

Replace the IPC. Refer to Instrument Cluster Replacement .

Did you complete the replacement?

--

Go to Step 6

--

Operate the system in order to verify the repair.

Did you correct the condition?

--

System OK

Go to Step 2